Operating Instructions KMR 1700 D English47! Take out the battery by the liftingloops! When fitting the battery makesure that you first connect thepositive post wire.! Check that the battery poles andpole connectors are protectedadequately with pole protectinggreaseCheck and top up thebattery acid levelDanger!Always heed safety precautions forhandling batteries!! DieTake-off the 6 cell caps! Draw a samble from each cellwith the battery hydrometer! Return each acid sample to thesame cellAt 20 °C, the acid of a fully-charged battery has a specificweight of 1,28 kg/lThe acid of a partially-chargedbattery has a specific weightbetween 1,00 and 1,28 kg/lThe specific gravity of theelectrolyte must be the same inall cellsBattery acid weight under 1,15 kg/l! If the battery acid level is too low,top-up the cells with distilledwater until the top edge of theplates is just covered with liquid! Charge the battery until a specificweight of 1,28 kg/l is reachedCharge the batteryDanger!! Always heed safety precautionsfor handling batteries!! Charge the battery with thesmallest possible chargingcurrent! It is essential to observe theinstructions provided by themanufacturerer of the chargingunit! Take-off all cell caps! Connect the negative pole lead ofthe battery charger to thenegative pole connection of thebattery! Connect the positive pole lead ofthe battery charger to the positivepole connection of the battery! Switch on battery charger andinsert mains plugFault instructionsThe engine will not start or runsirregularly after starting— Sit on the driver seat— Charging or replacing battery— Fill up with fuel or ventilate fuelfeed system— Replace fuel filter— Repair and clean the fuel feedline— Check the petrol line system,couplings and connections— Clean the air filter or replace thefilter cartridge— Notify dealerThe engine runs hot— Top up coolant— Purge the cooler— Tension V-belt— Notify dealerSweeping machine is movingonly slowly or not at all— Release parking brake— Clean the tyres or drive through acleaning solution— Notify dealerWhistling noise in the hydraulicsystem— Top up hydraulic fluid— Notify dealerThe brushes rotate only slowly ornot at all— Notify dealerLittle or no suction power inbrush area— Clean filter— Notify dealerMachine making dust— Replace the sweep roller— Clean dust filter— Replace filter seals— Adjust or replace sealing strips— Notify dealerSweeper unit does not pick uprefuse— Empty the swept materialcontainer— Clean dust filter— Replace the sweep roller— Adjust the sweep mirror— Remove blocking of the mainbrush— Replace debris container –sealing strips— Adjust or replace sealing strips— Notify dealerBin cannot be raised or lowered— Notify dealerBin turns too slowly or not at all— Empty the swept materialcontainer— Notify dealerProblems with hydraulicallyactuated components— Notify dealerPerformance dataSweeping performancedataTheoretical area performanceWithout side brushes10750 m²/hWith side brushes14000 m²/hOperating speed 0...10 km/hDriving speed 10 km/hWorking widthsWithout side brushes1075 mmWith side brushes1400 mmGradability 11,5°/ 20 %Sweep container volumeTotal volume300 litresUsable volume130 litresFilter-/suction systemFilter surface area 9 m²Intake volume 2200 m³/hNegative pressure 1500 PaAutomatic electric motor vibratorsystem