Kärcher SE 5.100 Manual

Also see for SE 5.100: Original operating instructions Manual Manual

– 8 Wet cleaning(see chapter "Fill wet cleaning/fresh wa-ter reservoir") Dry vacuum cleaning(see chapter "Dry vacuuming") Wet vacuum cleaning(see chapter "Wet vacuuming")Illustration Insert and lock the appliance head.Illustration Attach the suction hose and the sprayhose to the connectors on the appli-ance.Note: Press the suction hose tightly intothe connector to lock it into place.Illustration Connect the spray/suction pipes and at-tach to the handle. Center the lockinglever when attaching it, turn clockwiseto lock. Attach the floor nozzle to the spray/suc-tion pipes and secure with locking lever.The appliance is now prepared for wetcleaning. Health risk, risk of damage!Check the object to be cleaned prior to us-ing the appliance in an inconspicuous placefor colour fastness and water resistance.Do not clean water-sensitive floor cover-ings such as wood floors (the moisturecould penetrate and damage the floor).Notes:Warm water (max. 50°C) will increase thecleaning effect.Only use detergent pump while operating.Avoid dry runs as well as unnecessarypressure buildup (dynamic pressure) asmuch as possible.In case of danger of overheating, the ther-mal protection switch shuts off the deter-gent pump. After cooling off (approx. 20min), the pump will be ready to use again.IllustrationYou can remove the water reservoir to fill it.Add 100 - 200 ml (volume depends on de-gree of contamination) of RM 519 into thefresh water reservoir, then add tap water -do not overfill (watch MAX marker). Use the wash floor nozzle. Work without the hard surface insert.Please only use the carpet cleaner RM 519.Do not clean laminate or parquet floors! Use the wash floor nozzle. Slide the attachment for hard surfacesonto the wash floor nozzle from theside.Illustration Insert the mains plug into the socket. Press the switch for vacuuming, suctionturbine is running.Illustration Close fully the surrounding air separa-tor at the handle.Illustration Press the switch for spraying, the deter-gent pump is ready.Illustration Use the lever on the spray handle tospray on detergent solution.Illustration For continuous spray, the spray levercan be locked; for this, activate thespray lever and pull the locking key to-ward the rear. Run across the surface to be cleaned inoverlapping paths. Pull the nozzle back-wards (do not push). Once the wastewater container is full,the appliance switches off automatical-ly.Note: Once the appliance shuts off,switch off the appliance, because theStart upWet cleaning of carpets/hard sur-facesFill the fresh water reservoirWet cleaning of carpeted floorsWet cleaning of hard surfacesStart workingEmpty the wastewater reservoir duringoperation16 ENDownloaded From Vacuum-Manual.com Manuals