GB - 9Technical Data2. Technical Data2.1 Operating conditionsStandard S t a n d a r d /classInstructionsDefinition according to EN 61800-2 Inverter product standard: rated specificationsEN 61800-5-1 Inverter product standard: general safetySite altitudemax. 2000 m above sea levelWith site altitudes over 1000 m a derating of 1 % per100 m must be taken into consideration.Ambient conditions during operationClimate Temperature EN 60721-3-3 3K3extended to -10…45 °CWith temperature over 45°C to max. 55°C a derating of5 % per 1 K must be taken into consideration.Humidity 3K3 5…85 % (without condensation)Mechanical VibrationTrack EN50155 max. amplitude of a vibration 1 mm (5…13 Hz)max. acceleration amplitude 7 m/s² (13…100 Hz)1 m/s² (100…200 Hz)Germ. Lloyd Part 7-3EN 60721-3-33M1Contamination Gas 3C2Solids 3S2Ambient conditions during transportClimate TemperatureEN 60721-3-22K3Humidity 2K3 (without condensation)Mechanical Vibration 2M1 15 m/s² (200…500 Hz)Surge 2M1 50 g/30 ms; drop from 0,25 m heightContamination Gas 2C2Solids 2S2Ambient conditions for the storageClimate TemperatureEN 60721-3-11K4Humidity 1K3 (without condensation)Contamination Gas 1C2Solids 1S2Type of protection EN 60529 IP20Environment IEC 664-1 Pollution degree 2Definition according to EN 61800-3 Inverter product standard: EMCEMC emitted interferenceCable-based interferences – C1/C2 see chapter 3.2.2.3Radiated interferences – C2Interference immunityStatic discharges EN 61000-4-2 8 kV / 6 kV AD (air discharge) / CD (contact discharge)Burst - control lines + bus EN 61000-4-4 2 kVBurst - mains supply EN 61000-4-4 4 kVSurge - mains supply EN 61000-4-5 1 kV / 2 kV Phase-phase / phase-groundImmunity to conducted distur-bances, induced by radio-fre-quency fieldsEN 61000-4-6 10 V 0,15-80 MHzElectromagnetic fields EN 61000-4-3 10 V/mVoltage variation /voltage drop EN 61000-2-1 +10 %, -15 %; 90 %Voltage unsymmetries /frequency changes EN 61000-2-4 3 %; 2 %