KEF PSW4000 Installation Manual

Also see for PSW4000: Brochure & specs Brochure & specs Brochure & specs Brochure & specs Brochure & specs

Contents

This device complies with Part 15 of the FCC Rules. Operation is subject tothe following two conditions: (1) this device may not cause harmfulinterference, and (2) this device must accept any interference received,including interference that may cause undesired operation.Warning: Changes or modifications to this unit not expressly approved bythe party responsible for compliance could void the user’s authority tooperate the equipment.NOTE: This equipment has been tested and found to comply with the limitsfor a Class B digital device, pursuant to Part 15 of the FCC Rules. Theselimits are designed to provide reasonable protection against harmful interference in a residential installation. This equipmentgenerates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may causeharmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged totry to correct the interference by one of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.• Consult the dealer or an experienced radio/TV technician for help.WARNING:Due to the mains switch being located on the rear panel, the apparatus must be located in an open area without anythingobstructing access to the mains switch.FOR UK:The mains lead is terminated with a moulded three pin plug.Should the plug on the flexible cord not be of the type for your socket outlets do not use an adaptor but remove the plug from thecord and discard. Carefully prepare the end of the supply cord and fit a suitable plug.The fuse must be replaced with one of the same rating.IMPORTANTThe wires in this mains lead are coloured in accordance with the following code:Blue: NeutralBrown: LiveYellow & Green: EarthAs the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying theterminals in your plug, proceed as follows:The wire which is coloured Blue must be connected to the terminal which is marked by the letter N or coloured Black.The wire which is coloured Brown must be connected to the terminal which is marked with the letter L or coloured Red.FOR EUROPE:A mains lead compatible with national earthing standards and complying with the local safety requirement is supplied.WARNINGTO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSETHIS APPLIANCE TO RAIN OR MOISTURE• A combined mainspower input lead andcountry specific mainsplug is provided.• Check before connectingto your local mainssupply that the localsupply voltage is thesame as that marked onthe rear panel. If it is not,check with your supplierbefore proceeding.CAUTIONRISK OFELECTRIC SHOCKDO NOT OPENCAUTION: TO REDUCE THE RISKOF ELECTRIC SHOCK, DO NOTREMOVE COVER (OR BACK).NO USER-SERVICEABLE PARTSINSIDE. REFER SERVICING TOQUALIFIED SERVICE PERSONNEL.Explanation of Graphical SymbolsThe lightning flash with arrowhead symbol,within an equilateral triangle, is intended toalert the user to the presence of uninsulated“dangerous voltage” within the product’senclosure that may be of a sufficientmagnitude to constitute a risk of electricalshock to persons.The exclamation mark within an equilateraltriangle is intended to alert the user to thepresence of important operating andmaintenance (servicing) instructions in theliterature accompanying the appliance.SAFETY INFORMATION