KEF T-2 Installation Manual

Also see for T-2: Brochure & specs

Contents

14English instructions GBControls and socketsModel T-2 Rear Panel1. Line in input socket2. Bass Boost3. Phase control4. Mains indicator lightPower ON - BlueStandby - RedPower OFF5. Auto/manual switch6. ‘ON/OFF’ switch (vacation switch)7. AC power input 100 - 240V AC 50/60HzPositioningAs the sub-bass (low frequency) sound produced by the subwoofer is non-directional it can be positioned almost anywhere in the room, although itshould not be placed too close to the listener. For optimum performancetry the subwoofer in different positions to find the best place for a boom-free sound.Connection to AV amplifier / receiverConnect to the amplifier LFE subwoofer output.All inputs work simultaneously.Set the subwoofer frequency on the amplifier / receiver to 120Hz (refer tothe amplifier / receiver manual).Ensure that the satellites are set to the appropriate configuration in theamplifier / receiver menu (refer to the speaker manual).Adjust the subwoofer volume on the AV amplifier / receiver to your desiredlevel (refer to the amplifier / receiver manual).TroubleshootingAdjusting the controlsBass BoostThe bass boost control is intended to adjust the response of the subwooferto compensate for room conditions and user preferences. Boost isswitchable between 0, +6 and +12dB at around 40Hz.Phase ControlThe phase control will normally be set at 0˚ but more output levelcan sometimes be achieved in the 180˚ position, particularly when thesubwoofer is far away from the satellite speakers.PLEASE NOTE:Volume ControlVolume control is implemented in the source equipment.Auto/Manual SwitchIn Auto mode the unit will remain in standby until a signal is sensed.In Manual mode the unit will remain on even when no signal is present.FAULT REMEDYMains indicator light does not come on. Check that the subwoofer is plugged into the mains supply and that any switches are on.Check any fuses (including the plug) or circuit breakers on the mains supply which may affect thepower to the subwoofer.Contact your dealer for further advice.Mains indicator light is on but no sound comesfrom the subwoofer.Check and adjust the level control.Check the output sockets on the source equipment are correctly switched and adjustedto provide sufficient level to drive the subwoofer.Check that all connections between the subwoofer and the source equipment arecorrect and adjust as necessary.If there is still no sound. Contact your dealer for further advice.