INSTRUCTIONS FOR USE ENGLISHEdge 28B 146 3082 000(2)2007-06 13SIDE BROOM HEIGHT CHECK ANDADJUSTMENTCheck that the side broom is at the correct height fromthe ground, according to the following procedure:Drive the machine on a level ground and lower theside broom.Keep the machine stationary and turn on the sidebroom for a few seconds.Turn off the side broom by pressing the switch (1),then lift it and move the machine.Check if the size and orientation of the print left bythe side broom are as shown in the figure (A, Fig. 1):the side broom must touch the ground along a circlearc ranging from "10 o'clock" position to "3 o'clock"position.If the print is not within specifications, it is necessaryto adjust the broom height, according to theprocedure shown in step 2.Turn the knob (13) clockwise or counter-clockwise toadjust the broom height up or down.Perform step 1 again to check that the side broom is atthe correct height from the ground.When the broom is too worn and can no longer beadjusted, replace it according to the procedure shown inthe following paragraph.SIDE BROOM DISASSEMBLY/ASSEMBLYCAUTION!It is advisable to use protective gloves whenreplacing the side broom because there can besharp debris between the bristles.Drive the machine on a level ground.Turn the main switch (1) to “0”.Lift the side broom.Loosen the knob (A, Fig. 2) inside the side broom, thenremove the broom (B) by disengaging it from the pins(C).Install the new broom on the machine engaging it on thepins (C), then tighten the knob (A).Adjust the height of the new broom according to theprocedure shown in the previous paragraph.1.•••••2.3.4.1.2.3.4.5.6.B CAS311350Figure 1S311351Figure 2103
