KERN 573xxNM Service Manual
           | |
7.4 Automatic Linearity Adjustment1. Turn ON the balance.2. Press and hold the TARE key approx. 10 seconds until [Factory Reset?]appears.3. Press MODE key until [Linear auto ?] appears.4. Press key to start the automatic linearity adjustment. The display appearsthe first linearity point, e.g. [L1 2000.0g ?].5. Confirm with key or press the MODE key to select another linearity point,which is outside the permissible tolerances, e.g. [L2 5000.0g ?] and confirm withkey. The display appears [Place Lin Weight].6. Place the required weight on the centre of the weighing pan and wait until you willget a stable weighing result.7. Remove the weight. Now balance is in weighing mode.8. Switch off the balance by pressing the ON/OFF-key.9. Now plug off the power supply and plug in again.Please notice the linearity points were defined and configured in our production line.Therefore it is not possible to change them afterwards without special configurationsoftware.7.5 Manual Linearity Adjustment1. Turn ON the balance. After warming-up time and adjustment check balancereadings in all measuring points. In case of differences make a note.2. Press and hold the TARE key approx. 10 seconds until [Factory Reset?]appears.3. Press MODE key until [Linear man ?] appears.4. Press key to start the manual linearity adjustment. The display appears thefirst linearity point, e.g. [L 2000.0g +00d].5. With the arrow keys , and you can change the stored value.6. Press the MODE key to select another linearity point, which is outside thepermissible tolerances, e.g. [L 5000.0g -07d] and inscribe the correction valuelike described above in point (5.) and so on.7. To return to normal weighing mode press TARE key once.8. Switch off the balance by pressing the ON/OFF-key.9. Now plug off the power supply and plug in again.Information:If there is a positive difference (e.g. 2000.6 g = + 6 digit) you should subtract this differenceto the stored value (e.g. [L 2000.0 -06d]).If there is a negative difference (e.g. 1999.4 g = - 6 digit) you should add this difference tothe stored value (e.g. [L 2000.0 +06d]).572-SH-e-0951 9 |
Related manuals for KERN 572xxNM
manualsdatabase
Your AI-powered manual search engine