KERN 770-12 Operating Instructions Manual

KERN 770-12 Operating Instructions Manual Manual pdf 25 page image

92 770/GS/GJ-BA-defsi-0023The current code setting in the balance operating menu is identified by a small,superscript “o“ after the last number. When you access the operating menu, thepreviously set code will be displayed after you have selected the right-hand number,which means the entire menu code setting will be displayed. This makes it easy for youto check the previously set menu codes.If you would like to change several menu code settings, you do not have to press theTARE key after each change to exit the balance operating menu. You can also confirmindividual settings.Important Note !By turning of the access switch an accidental alteration of the menu settings can beavoided.You can make this setting anytime you wish once you have accessed it. However, it isbest if you wait to lock the menu until you have changed the last code setting.Leaving the Menu without Storing Changes to the Code SettingsChanges to the code settings are not stored if you turn off the balance by pressing theON/OFF key while changing the settings and before saving them.3.1.2 Reset Function - Undoing All Menu Code ChangesThe reset function enables you to undo all menu code changes, which means that youwill obtain the original factory-set menu codes identified by an “*“. To use this function,select code 9--1!.See the previous page for information on confirming and storing a menu code setting.