KERN MWB series Service Manual

MWB-SH-e-1810.docx 117 Unpacking, Setup and Commissioning7.1 Place of installation / place of operationThe balances are designed in a way that reliable weighing results are achieved in commonconditions of use. You will work accurately and fast, if you select the right location for yourbalance.On the installation site observe the following: Place scales on a stable, even surface Avoid extreme heat as well as temperature fluctuation caused by installing next to aradiator or in the direct sunlight; Protect the balance against direct draughts due to open windows and doors; Avoid jarring during weighing; Protect the balance against high humidity, vapours and dust; Do not expose the device to extreme dampness for longer periods of time. Non-permittedcondensation (condensation of air humidity on the appliance) may occur if a coldappliance is taken to a considerably warmer environment. In this case, acclimatize thedisconnected appliance for ca. 2 hours at room temperature. Avoid static charge of the balance and of the person to be weighed. Avoid contact with water.Major display deviations (incorrect weighing results) may be experienced shouldelectromagnetic fields (e.g. due to mobile phones or radio equipment), static electricityaccumulations or instable power supply occur. In that case, the location must be changed.7.2 UnpackingRemove the individual components of the balance or the complete balance from thepackaging with care and install at the intended location. When using the power pack, ensurethat the power cable does not produce a risk of stumbling.7.3 Scope of delivery Balance, completely assembled Operating manual7.4 Levelling Level balance with foot screws until the air bubble of the waterbalance is in the prescribed circle. Check levelling regularly.