KaVo ELECTROmatic M Instructions For Use Manual

Also see for ELECTROmatic C: Instructions for use

Contents

KaVo ELECTROmatic M Instructions For Use Manual Manual pdf 50 page image

Instructions for use ELECTROmatic M/C and PM/PC5 Commissioning | 5.1 Connection50 / 805.1.4 Connect the motor cord▶ Plug the motor hose onto the motor hose connector on the rear of theELECTROmatic device and screw it tight.▶ Set the spray regulation on the hose to maximum amount of water.See also:2 6.3 Regulating the spray water, Page 575.1.5 Connect the power supplyCAUTIONPower supply and cords/hoses are on the floor.Slipping and tripping.▶ Power supply and cord/hoses need to be set-up/routed appropriately suchthat they are not on the floor.NOTICEProperty damage from non-approved power supply.Property damage to the product.▶ Operate the product with the type 4882 power supply (Mat. no.1.005.0120) exclusively.NoteThe connection of the power supply must comply with the country-specificregulations and requirements for medical devices.NoteThe power supply automatically adjusts to the available mains voltage.NoteGrounding reliability can only be achieved when the equipment is connectedto an equivalent receptacle marked "Hospital Only" or "Hospital Grade".NoteThe protective earth conductor is used as functional earthing (FE) rather thanas protective earthing (PE).NoteUse the power supply in dry environments exclusively. Make sure that thepower supply is protected from the ingress of liquids.