Instructions for use ELECTROmatic M/C and PM/PC3 Description of the product | 3.1 Intended use16 / 783 Description of the productThe ELECTROmatic is a dental treatment centre for operation of the dental elec-tric small motor, INTRA LUX Motor KL 703 or the COMFORTdrive motorisedhandpiece.The following versions of the product can be ordered:▪ ELECTROmatic M▪ ELECTROmatic C▪ ELECTROmatic PM▪ ELECTROmatic PCSee also:2 3.2 Scope of delivery, Page 17Only the ELECTROmatic PM/PC version of the product is depicted in the follow-ing. The descriptions apply to all versions of the ELECTROmatic M/C andELECTROmatic PM/PC product, unless explicitly stated otherwise.3.1 Intended useIndications for use:The ELECTROmatic is intended to convert pneumatic output from a dentaltreatment center to electrical energy to drive the COMFORTdrive motor hand-piece and the INTRA LUX KL 703 LED motor for operation of electrically-drivendental handpieces. This device is designed for use by a trained professional inthe field of general dentistry.Proper use:The overarching guidelines and/or national laws, national regulations and therules of technology applicable to medical devices for start-up and use of theKaVo product for the intended purpose must be applied and followed.Definition (purpose) ExplanationMain function Dental treatment for preparations andendodonticsApplication For dental treatment of humansCrown and root of the toothSpecification of the primary function Mains-dependent accessory device forthe dentist unitDuration of use Approximately 30 - 40 minutes with in-dividual pausesKaVo shall not be responsible for damage caused by:▪ external influences, poor media quality or faulty installation.▪ The use of incorrect information.▪ Repair work carried out incorrectly.▪ If the 2-year service check have not been done