Kaba E-PLEX Installation Instructions Manual

Contents

Kaba E-PLEX Installation Instructions Manual Manual pdf 21 page image

21K. TESTING THE OPERATION OF THE LOCKK-1 Rotate inside lever and hold. Ensure that the mortise latch is fully retract-ed and flush with the mortise faceplate. Release the inside lever; the latchshould be fully extended.K-2 Enter the factory-set combination: 1,2,3,4,5,6,7,8. You should see a greenlight and hear a high-pitched tone as you push each button. When the lockopens you will briefly hear the sound of an electric motor. If 1,2,3,4,5,6,7,8does not seem to work, please follow the steps to perform a hard reset byfollowing the procedure in section L.K-3 Rotate outside lever and hold. Ensure that the latch is fully retracted andflush with the latch faceplate. Release the outside lever; the latch shouldbe fully extended. When the lock re-locks, you will again hear the motor.K-4 Insert key into the outside lever. Rotate key counterclockwise to stop posi-tion and hold. Ensure that the latch is fully retracted and flush with thelatch faceplate. Rotate the key clockwise to the horizontal position andremove the key. The latch should be fully extended.K-5 To test the deadbolt function (where applicable), turn the thumbturn knobto extend the deadbolt. A red light should flash once. Then, turn thethumbturn again and verify that the deadbolt is retracted and there is aflash of the green light.Note: Refer to the Operating Manual to set up lock operation.L. PROGRAMMING AND SOFTWARE SETTINGS:L-1 You must change the master Code from the factory default to anothercode to program the lock. For further information on how to manuallyprogram the E-Plex 3x00/5x00 Series Models, refer to the companion “E-Plex 3x00/5x00 Operation Manual.” Software is required to program theE3200/E5200 Series Locks.L-2 When configuring the E3000/E5000 Series Locks using the optionalStandard Software, choose the box that contains “Entry Lock withPassage (Cylindrical or Mortise without Deadbolt)” during lock setup.L-3 When configuring the E3200/3700 and E5200/E5700 Series Locksusing the Enerprise Software, select the appropriate lock type duringlock setup.

/ 24

Related manuals for Kaba E-PLEX