Kaba E-Plex 5X10 Installation Instructions Manual

Contents

Kaba E-Plex 5X10 Installation Instructions Manual Manual pdf 15 page image

11I-7 Using two pairs of pliers, break the tailpiece to the desired length of theintended application by holding one pair of pliers on the good side of thescore mark and a second pair on the other side of the score mark. Slowlymove the 2nd pair of pliers up and down until the unneeded portion ofthe tailpiece breaks free.I-8 Insert the Medeco tailpiece (e) vertically into the outside lever as shown.Make certain that you rotate the tailpiece slightly so that it will align withthe interchangeable/removable cylinder. Insert theinterchangeable/removable cylinder into the outside lever.Note: To remove the outside lever from the outside unit assembly, followsteps below.I-9 Remove the interchangeable/removable cylinder. Then remove the tail-piece (e).Note: You may want to use needle nose pliers for some tailpieces.I-10 Insert the lever release tool (d) into the small hole (f) under lever asshown. Gently push lever catch up until it clicks. Remove tool, thenremove outside lever (a).J. INSTALLING E5x00 EXIT TRIMNote: Prior to mounting the lock,ensure the handing is set correctly asthe tailpiece may have shifted duringhandling (see section F).Warning: If using a power drill, becareful not to over-tighten as this couldcause damage to the mounting screwsand threads.J-1 Guide the Unit Assembly so the Tailpiece (a) engages the vertical slot inthe hub of the exit device. The key override may be utilized to test theoperation to make sure that the tailpiece is engaged with the exit devicehub before fastening assembly to the door. The outside unit assemblymust be held in place by hand until fastened with LectroBolt.J-2 Place the Battery Mounting Plate (b) on the door such that the red collaris inside the lower of the top two 3⁄8" diameter holes and hold in place byhand until fastened with LectroBolt.J-3 Select the LectroBolt (c)(screw with red sleeve) length that correspondsto the correct door thickness: use the 3" screw for thickness range from1 3⁄4 " to 2", for door thickness of 2 1⁄8" to 2 1⁄4" use the 3 1⁄8" longLectroBolt included in the Thick Door Accessory pack.deaf ghbc