Kaba e-plex 2000 Installation Instructions Manual

Also see for E-PLEX 2000: Operation manual Operation manual Installation instructions Quick reference guide

Contents

Kaba e-plex 2000 Installation Instructions Manual Manual pdf 9 page image

16J. INSTALLING LOCK HOUSINGSJ-1 Insert the slotted end of the square spindleinto the outside lever hub until it locks, at anangle of 45º. (The spindle can be removedby pulling on it, if oriented incorrectly.)J-2 Assemble gasket onto the out-side housing (a). Assemblecylindrical plate assemblyonto the outside lock housing.J-3 Place the outside housing (a) andcylindrical plate assembly on thedoor so that spindle engages hubof cylindrical unit of latch.J-4 On the inside trim assembly, turn the lever tothe correct horizontal rest position for thehanding of the door. Install the tension spring(l) between the handle (h) and the post (p).(outside)cylindricalunitlatchaGasketCylindrical PlateAssemblySquare Spindle Positioncorrect incorrecthpl17J-5 Place the inside trim assembly onthe door so that the spindles (o)engage the inside lever. Fastento the outside housing using thethree 1⁄ 8" (3 mm) hex drivemounting screws (p).K. INSTALLING BATTERY PACKNote: If the lock makes a continuous buzzing noise or the red LED lightscontinuously, reset the electronics by removing the battery holder for tenseconds, then reinsert it.K-1 Three AA batteries should already beinstalled in the battery holder (q).K-2 Insert the battery holder into the outsidehousing and secure it using the 6-32 x 5⁄ 16 "(8 mm) screw (r).poqr

/ 10

Related manuals for Kaba E-PLEX 2000