Kalfire G Series User Instructions

Also see for G Series: Installation instructions

Kalfire G Series User Instructions Manual pdf 17 page image

17Buttons:a. + and - buttonsb. Left button and rightc. Centre buttond. On/off buttone. Parameter configuration button P4.3 Setting day and timeSetting day and time.Carry out the following steps to changethe day and time settings:1. Hold down the P button until thetime display starts flashing.2. Change the hour with the +orbutton and confirm the change bypressing the centre button.The minutes will then begin to flash.3. Change the minutes with the + orbutton and confirm the change bypressing the centre button. Thenumber indicating the day of theweek will then begin to flash(1 = Monday).4. Change the day with the +or buttonand confirm the change by pressingthe centre button.5. To exit the parameters menu, press P.6. Wait for 30 seconds while the infor-mation is transmitted.4.4 Checking transmission strengthCarry out the following steps in orderto modulate transmission strength bet-ween gas fire and the remote control.1. Press P until the transmissionstrength flashes at the top left of thedisplay.2. Press the right button until RFCKappears in the display.5. The flame is ignited if the icon isalight, if this icon is flashing one ofthe following notifications requiresyour attention: heat adequacy, igni-tion attempt or reignition attempt.6. The ECO mode is activated.7. Batteries are flat.8. Room temperature and othernotifications such as disruptions.9. Warning signals related todisruptions.10. Time segments11. Thermostat mode.12. Manual programme (default mode).1 23456781091112e.d.c.b.a.