Kalfire G Series User Instructions

Also see for G Series: Installation instructions

Kalfire G Series User Instructions Manual pdf 19 page image

19“TCOM” (temperature comfort).TCOM indicates the maximumtemperature during all set timesegments.5. Set the desired temperature with the+ or - buttons at increments of 0.5°C.6. Confirm by pressing the (centrebutton).7. “TECO” (temperature ECO) will nowappear in the display. TECO is theminimum temperature between thetime segments. This minimum tem-perature will be maintained all daywith the exception of the set timesegments.8. Set the desired temperature with the+ or - buttons at increments of 0.5°C.9. Confirm by pressing the (centrebutton).10. Press the right button , so that aflashing time in hours and minutesappears in the top left-hand corner,while “ON 1” appears in the middleof the display (this is the first “on”time).11. Use the + and - buttons to set thefirst “on” time at increments of15 minutes.12. Confirm by pressing the centre but-ton if you are happy withthe time.13. “OFF 1” will then appear (this is the first“Out” time).14. Use the + and - buttons to set thefirst “out” time, at increments of15 minutes.15. Confirm by pressing the button.16. Programme the other times in thethree segments in this way; shouldyou not require all time segments,these other segments should be set4.8 Setting the flame intensity bythermostatThe remote control measures thetemperature and the flame intensity ismodulated accordingly. To ensure anaccurate temperature reading, makesure the remote control is outside ofthe fire’s radiation range.1. Select the thermostat programmeas indicated in paragraph Selectingthe thermostat or manual operatingprogramme on page 18.2. Press the button with the +or withthe so that the temperature indica-tor on the display starts to flash.3. Set the desired temperature with the+ and buttons.4. Wait for 10 seconds before using theremote control to save the set tem-perature.4.9 Programming time segmentsThe thermostat function can be com-bined with a timer programme thatallows for up to three time segments tobe programmed. These are indicated byswitch-on times ON 1, 2, 3 and switch-off times OFF 1, 2, 3. The set program-me will run daily.1. Check if the hand transmitter is setat the right time (if you are not hap-py with the time, see: 4.3 Day andnight settings)2. Press the P button (hold down brie-fly).3. Let go of Button P when the timestarts to flash in the top left-handcorner of the display.4. Press the right button to display