Kallista P50045-G5 Homeowner's Manual
                | |
HOMEOWNERS GUIDEBath with Airjets1096755-5-D5 of 16Questions? Problems? For additional assistance, please contact KALLISTA’s CustomerService Department at 1-888-4-KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.USER KEYPAD AND BATH WITH AIRJETS MODES/FEATURESRotating Ring Key PadPurge ModeDecrease Flow or SurgeIndicator BarIncrease Flow or SurgeSurge ModeZone 3Power On/OffZone 1Air Flow ModeActivates Mode SelectedZone 2Rotate outer ring toaccess desired mode. Power On/Off - Turns the blower motor on and off. Symbols illuminated in blue indicate available modes/features. Modes which are operating will display in green. Activate Button - Press “OK” to activate the desired mode. The active mode will flash (green). Up Arrow - Increases the air flow when the air fl ow mode is active. Increases the pulse speed when thesurge mode is active. Down Arrow - Decreases the air flow when the air flow mode is active. Decreases the pulse speed whenthe surge mode is active. Outer Ring - Rotate the outer ring to the desired mode. The selected mode will flash (blue). Indicator Bar - Shows the air fl ow volume when operating in the air flow mode. Shows the surge speedwhen operating in the surge mode. Purge Mode - Select to initiate the purge mode manually. The purge cycle will not start if there is water inthe bath. The purge mode blows any residual water out of the air channels. The blower motor starts andruns at a low speed for about two minutes. An automatic purge cycle occurs when the bath is drained andthe water level falls below the level sensors. Air Flow Mode - In this mode, air flow is directed through any combination of the airjets in the selectedzones. Air flow can be adjusted with the arrow buttons. When the surge mode is selected, the air flow modestops. When the air flow mode is selected while operating in the surge mode, the surge mode stops. Zone 1 - This mode is used to select or deselect the air flow through Zone 1. Zone 2 - This mode is used to select or deselect the air flow through Zone 2. Zone 3 - This mode is used to select or deselect the air flow through Zone 3. Surge Mode - When active, the air flow ramps up from minimum to maximum and then down again tominimum. The surge speed is adjustable between 10 seconds to 60 seconds by using the up or downbuttons. The up and down arrow buttons can be used to adjust the surge speed. Zones can be selected ordeselected when in the surge mode. |
Related manuals for Kallista P50045-G5
manualsdatabase
Your AI-powered manual search engine