Kasco 3400EVFX Owner's Manual

Also see for 2400EVFX: Operation & maintenance manual

Kasco 3400EVFX Owner's Manual Manual pdf 5 page image

5cushionlogoSTEP THREEEnsure correct alignment by twisting the float gentlyaround the motor housing until the fl oat “locks” intoplace, the bolt holes in fl oat line up with bolt recep-tacles on unit and power cord guide lining up with thecord. See diagram below of bottom side of float.Bolt holespower cordguideSTEP FOURUse one of the 1/4”-20 x 3-1/4” Phillips Pan HeadScrews (Part C), one 1/4” split washer (Part N), anda 1/4” Flat Washer (Part D) to secure the fl oat. Makesure the split washer goes between the bolt head andthe fl at washer. Insert screw with washers throughbolt hole in floatSTEP FIVETurn secured assembly upside down so the top of thefl oat (logo side) is face down on the fl at surface. PlaceBottom Screen (Part J) onto the bottom side of thefl oat. Make sure the wide opening of the screen isAlso included: (not pictured)L. Cushions for fountain housing legs (4)M. Cushions for bottom screen (3)N. 1/4” split washers (4)TOOLS & SUPPLIES NEEDEDA. Anchors or stakes for installing unit (2)B. # 2 Phillips head screw driverC. 208-240V Electrical Supply near pond on a postD. Two 30cm pieces of 2.54cm galvanized pipe forweighting ropes (optional)E. 9/16” (14mm) Socket and RatchetF. 9/16” WrenchEVFX Pattern Size ChartAll produce a V-shaped display.Model Height Width2400EVFX 1.15 m 4.3 m3400EVFX 1.7 m 6.1 m4400EVFX 1.7 m 6.7 m2400EVX, 2400EJ, 3400EVX,4400EVX Assembly InstructionsSTEP ONEMake sure you have all the parts needed. If any short-ages are found, contact your Kasco representativeimmediately.STEP TWOSet motor housing upright (stainless steel can down)on a flat surface.Peel off the adhesive on one of the cushions (Part L)for the fountain housing legs. Stick to the top of thefountain housing leg and repeat for the other threecushions and legs. Slide float (Part B) over pumphousing and rest the float on the 4 legs of the housingmaking sure the Kasco logo is up.