33SAT39 Write N1 Set port group 1 13A Write N2 Expansion option 13B Write N3 Expansion option 140 Read A0 Read analogue value A0 -41 Read A1 Read analogue value A1 -48 Write A0 Set analogue value A0 149 Write A1 Set analogue value A1 14F Write A7 Set analogue value A7 150 LO string Read instantaneous frequency -51 LO now Read instantaneous frequency (table entry number) -52 LO Lo Read Lo frequency (table entry number) -53 LO Hi Read Hi frequency (table entry number) -58 Write Freq Write channel frequency 2 or 359 Ch.No. Set selected channel number (receiver) 260 Halt Stop positioner -61 Go E Move positioner eastward -62 Go W Move positioner westward -64 P Status Rear positioner status register -65 Read Pos Read positioner counter -6C Goto Move positioner motor to “Counter Value”, Hi, Lo 26D Write Pos Set “positioner counter”, Hi, Lo 2COMMAND OVERVIEW FOR “DATA BYTE”An appropriate data byte must only be sent if the command byterequires data bytes. This can be seen from the above commandbyte table. For more information on which data byte to send to whichcommand byte, please refer to the specification of the device used.OrbitpositionPolarisationSwitch PositionH/VSwitch PositionLNB Band Data Byte1V Lo F0V Hi F1H Lo F2H Hi F32V Lo F4V Hi F5H Lo F6H Hi F73V Lo F8V Hi F9H Lo FAH Hi FB4V Lo FCV Hi FDH Lo FEH Hi FF
