Kathrein UFD 400 Operating Manual

Also see for UFD 400: Operating manual Mode d'emploi

Kathrein UFD 400 Operating Manual Manual pdf 4 page image

Controls, displays and connections4Front panel controls and displays Rear panel controls and connections1Mains switch (with mains isolation)2Buttons for programme selectionStep-by-step programme selection (upwards and down-wards).Switchover from TV to radio mode by pressing both buttonssimultaneously.3LED display (four character 7-segment display)To display the selected programme slot and parameter set-tings.1Mains input socket for 230 V/50 Hz2DATA socketa) Connection facility for the URS 200 external infraredsensor.b) Connection for the UFP 10 Copy-Programmer forread-in and read-out of the programme data(function b is especially for service, for copying theprogramme data).3VHF/UHF antenna input (signal is looped through).4VHF/UHF antenna output(TV signal modulator-output, Ch. 38 is preset)5 Satellite IF signal input A andoutput of LNB supply voltage6Audio output, left and right channel (Cinch sockets)7 Scart socket, TV connection8 Scart socket, VCR connection9 Scart socket, decoder connectionRemote control handset keysFunction 1:Command set changeoverFunction 2:To blank out the video signal (in setup mode) Thisfunction is to be used if the picture no longer synchro-nises on adjustment and the picture scrolls.Starts a timerLast function. Allows you to switch back to the last pro-gramme that was selectedFunction 1:Last function. Allows you to switch back to the lastprogramme that was selectedFunction 2:Displays the info menu(active only if after pressing the key theprogramme list is displayed.)Function 1:On/Off (Standby),Attention: No mains isolation results!Function 2:Return from setup mode into normal operationFunction 1:Calls up the TV programme list (or radio programmelist in radio mode).Function 2:Calls up menu for "Programme slot sorting (insertion),swapping and copying“(with press in succession)Set timer, date and timeFunction 1:Selection of TV/SAT modeFunction 2:Calls up the menu for video settings(with press in succession)Function 1:Volume controlFunction 2:To alter settings data in setup modeFunction 1:Steps through the programmes either up or downFunction 2:Selection of individual menu entries in setup modeFunction 1:Stores the chosen settingsFunction 2:Primary key for calling the separate setup menus (e.g.video settings)Function 1:Switchover to radio modeFunction 2:Calls up the menu for radio settings(with press in successionFunction 1:Sound muting)Function 2:Calls up the menu for audio settings(with press in succession) toStereo/Mono- (2 channel) changeoverNumeric keys 0 - 9 for programme selection and fre-quency entries