Kathrein UFD 400 Operating Manual

Also see for UFD 400: Operating manual Mode d'emploi

Kathrein UFD 400 Operating Manual Manual pdf 17 page image

Programming TV programmes17Programmieren von TV-ProgrammenThe satellite receiver has already been factory pre-programmed for satellite re-ceiving systems with feed systems (receiving system) which have an oscillator fre-quency of 9.75 GHz. All of the programmes set up are listed in the table enclosed.If your satellite receiving system uses a feed system with a different oscillator fre-quency, the receiver only needs to be matched to the feed system oscillator fre-quency during the installation.The procedure for this can be found in section: “Initial settings, Oscillator fre-quency“.Note on programme memory locationsThe receiver has a 250 channel memory that can be assigned with TV or radioprogrammes in any given manner.The receiver has been factory pre-programmed according to the programme tablewith:150 TV programmes and100 radio programmes.Programme memory is organised here so that the TV programmes are located inprogramme slots from 1 upwards while the radio programmes are located in pro-grammes slots from 250 downwards. See also the following display:Since only one sound programme (TV accompanying sound or a radio programme)can be stored in a programme memory, with the factory presetting:in “TV mode“on reception of TV programmes in programme slots 151 to 250 the original TVsound is not sent but instead the programmed radio soundin “radio mode“on reception of radio programmes from programme slots 101 to 250 the sound ofthe corresponding TV programme is sent.The assignment of the programme slots can be changed as desired.Tuning in TV programmesTo tune in to new TV programmes, the video and audio reception parameters needto be set up accordingly.The latest programme assignments can be obtained from satellite programmemagazines, or called up via the videotext of programme Sat 1 from page 675.• Select the programme slot that you want to change.• Call up the video menu by pressing the + keys in succession.orAll manuals and user guides at all-guides.com