Kathrein UFD 400 Operating Manual

Also see for UFD 400: Operating manual Mode d'emploi

Kathrein UFD 400 Operating Manual Manual pdf 23 page image

Initial settings23GrundeinstellungenIn the initial setup menu, matching of the satellite receiver to the satellite receivingsystem is carried out.Important The receiver has already been factory pre-programmed for standard satellite re-ceiving systems.Alterations to the initial setting are therefore necessary only if your receiving sys-tem deviates from this type of installation or if you happen to want different set-tings.The settings in the initial setup menu are generally carried out by the specialistdealer on installation of the satellite receiving system.To prevent any unintentional alterations in the initial settings, the initial setup menucan be invoked only from the switched-off state.Calling the initial setup menu• Switch the unit into standby.• Press both the programme selection buttons (2) on the receiver si-multaneously and keep them pressed.• Switch the unit on via the key on the remote control.• Release the buttons when “C 38“ appears on the LED display.C 38 is the factory preset UHF output channel. If the UHF channel has alreadybeen altered, the appropriate channel selection appears(between Ch. 21 and Ch. 69).The initial setup menu is displayed.Setting option:Modulator: channel 21 to 69OSD language: bilingual German / EnglishLNB supply voltage: Off / OnLNB power supply in standby: Off / OnProgramme selection: 1-/ 2-/ 3-digit / free entryOSD: Off / On (can be set individuallyfor TV and radio)Type of remote control: 26 or 24 keys.Oscillator menu: LO 1 to LO 4DiSEqC menu:See separate menu in section “DiSEqC"The bottom line shows the keys you can use to make the settings.Settings are made in the initial setup menu in the same manner as in the othermenus for the station programming:• Select menu entries with the keys.• Carry out settings and call up submenus with the keys(and use numeric keys .. on inputting frequency).• Press the key twice to save your settings.• Return with the key.Modulator-output channelThe modulator‘s UHF output channel can be entered in the range from channel 21to 69.Default: channel “38“All manuals and user guides at all-guides.com