Kathrein UFD 505 Operating Manual

Also see for UFD 505: Mode d'emploi Mode d'emploi

Contents

Kathrein UFD 505 Operating Manual Manual pdf 39 page image

Installation menuAfter an unsuccessful search the following message appears:All new programmes are added to the existing programme list.Under the menu item „Delete TP“ you can remove the transponder from the pro-gramme memory by pressing . You will be requested to confirm that you wishto remove the transponder before it is deleted.DiSEqC (UFO) Set-upYou should only make changes in this menu when the receiver is to be connectedto another receiving system with differentfeatures or if changes have been made tothe receiving system.Therefore, take particular note of the information relating to your Sat-IF system. Be-fore making any changes, you should make a note of these settings on the formprovided at the end of this User's Guide.Press the menu buttons , and to open the DiSEqC menu.Error22-kHz signalIn this menu point you can determine whether the 22 kHz signal is to be used toswitch over between the low and high frequency range of a satellite or between 2satellite positions.Tone-burst and DiSEqC signalA DiSEqC control signal is necessary if more than four control criteria are requiredin a receiving system.Which of the setting options, i.e. tone burst or DiSEqC, is required depends on thecomponents of the receiving system.Therefore refer to the description of the components (switchover matrices) of thereceiving system.39