Kathrein UFD 506 User Manual

Also see for UFD 506: Notice d'utilisation

Kathrein UFD 506 User Manual Manual pdf 15 page image

Channel Selection15r E cTimerThe “Timer Programming” menu is selected in the main menu underitem 5. Up to 8 timer events can be entered optionally with TV or radiochannels.Note: Please note that in the selection “VCR Record = Standard” the videorecorder must also be set to identical recording times (see also signalpaths / VCR record).Note: Please note that no remote control commands are accepted during atimer recording, so that OSD picture displays are not recorded unin-tentionally. The volume is switched to full level for recording. As indi-cation that a timer recording is active, “r E c” is displayed on the pro-gramme display on the receiver if a command is received from theremote control.The timer recording can be stopped prematurely only by the [ ] but-ton = stop button. “End” is displayed after stopping. The receiver cannow be operated normally again.If the timer recording is started from stand-by, then the receiverswitches back to stand-by after the end of recording.[1-8] Select the next free input field with thenumber buttons [1]-[8] or with [▼] or [▲].[►][◄] Select the input field for {Date}, {Start}, {Stop} and{Channel} one after the other.(The input field is highlighted white).[OK] Activate the input in the selected field with the [OK] button.(The input field is highlighted black).Enter the relevant event either directly with the number buttons [0]-[9]or by switching on with the [►]/[◄] buttons.[OK] Close the entry with [OK] and select the next input field.[EXIT] After entering {Date}, {Start}, {Stop} and {Channel} you canleave and acknowledge the timer menu with [EXIT] or enterfurther switch-on events.The data from the programme preview can be transferred to the re-cording timer at the push of a button. If a programme preview is avail-able, select the desired programme and transfer the data with the redbutton [●] directly into the timer.Deleting timer programming:[1-8] Select the timer line to be deleted with the number buttons[1]-[8] or with [▼] or [▲]E n d