Kathrein UFS 640si Operating Manual

Contents

51SatelliteUsing the buttons, select the satellite to be scanned. Make sure your reception system is aligned tothe selected satellite. You can search only one satellite at a time. If you have connected a multi-feed receptionsystem (e.g. reception of ASTRA 19.2° East and HOTBIRD 13° East), you must repeat this procedure oncefor each satellite. You can however start the first installation again, in the course of which a channel searchof all the satellites you selected is performed.Press the button to move to the next selection item.Channel Search ModeUse the buttons to select whether you wish to search “free & encrypted” or “only free” channels.Press the button to move to the next selection item.Network SearchUse the buttons (On/Off) to select whether a network scan should be performed. If you set thenetwork search to “Off”, only the factory stored transponders of the satellites you previously selected will besearched for new as yet unlisted channels.If you set the network scan to “On”, the transponder network enables additional transponders that have notyet been stored to be located. They are then stored and searched for new channels in the same way as theexisting transponders.When you have made your settings, use the buttons to select “Start Search” and press the button to start scanning. You can cancel the scan at any time by pressing the button. During the searchyou will see the following message (example):TV channelsfoundRadiochannels foundProgression barSatellite with thetranspondercurrently beingsearchedSEARCH CHANNELS (CHANNEL SEARCH)