Kathrein UFS 902 Operating Manual

Also see for UFS 902: Function guide

Contents

Kathrein UFS 902 Operating Manual Manual pdf 8 page image

8CONNECTION AND SETUPThe following section is intended specifically for specialist dealers. You need not refer to this section unlessyou are carrying out the installation yourself.The “Connection Examples” section provides a sample configuration.Do not connect the receiver to the power supply until all installation work has been properly carried out.Refer to the information in the “Safety Instructions” section.Connect the Sat IF input on the receiver to the satellite reception system. Use acoaxial cable with a standard F connector.If the F standard connectors are not yet fitted on the cable, strip the insulationfrom the cable as shown in the following illustration and carefully twist theF standard connectors on to the ends of the cables until they are securely seated.When fi tting the connector, make sure that no wires from the braid are touching theinner conductor, so no short circuit can occur.The quality of the reception signal depends on this connection!The presets for the control signals have been made for standard reception systems, i.e. 14/18 V for polarityreversal and 22 kHz switching signal for low/high band changeover on multi-feed reception systems.CONNECTING THE UNIT (SAT IF CONNECTIONS)RECEPTION REQUIREMENTSMake sure that your satellite antenna system is equipped at least with a universalLNB for digital reception in the high-band range.RECEPTION SYSTEM PRESETS