Kemppi FastMig MXP 37 Pipe Steel Operating Manual

Also see for FastMig MXP 37 Pipe Steel: Operating manual Operating manual

Contents

Kemppi FastMig MXP 37 Pipe Steel Operating Manual Manual pdf 18 page image

EN3.3 Button functions3.3.1 ON/OFF button (1)XF 37W007241CH REMOTECHANNELPANEL4T2TShort press: XF 37 / X 38 panel returns to initial display.Long press: XF 37 / X 38 panel is turned ON or OFF.NOTE! When wire feeder XF 37 / XF 38 control panel is turned ON, also the power source controlpanel X 37 turns on and links automatically to this wire feeder.3.3.2 Dynamics button (2)XF 37W007241CH REMOTECHANNELPANEL4T2TShort press: Dynamics setting for 1-MIG, synergic MIG and CC/CV. ArcForce setting for MMA.Long press: Wire feeder number selection. If there is more than one wire feeder connected tothe system, you can select which of them is active. Each wire feeder has its own number (1–3).NOTE! Wire feeder number is not available in MMA, CC and CV processes.3.3.3 Gas test button (3)XF 37W007241CH REMOTECHANNELPANEL4T2TThis button displays the gas test time. You can change it with the control knob.Gas test starts when the time adjustment is made, after a short delay.You can stop gas test by pressing any button.3.3.4 Wire inch button (3)XF 37W007241PANEL4T2TThis button starts feeding the wire with the default speed of 5.0 m/min. The wire feed stopswhen you release the button.You can change the wire feed speed with the control knob. The changed speed is used if youpress the button again.3.3.5 Channel down button (5)XF 37W007241CH REMOTECHANNELPANEL4T2TWISEROOT+/This button selects the previous memory channel that can be found.3.3.6 Channel up button (6)XF 37W007241CH REMOTECHANNELPANEL4T2TWISEROOT+/Short press: Selects the next memory channel that can be found.Long press: Locks or unlocs the selected memory channel. No parameter changes are allowedto a locked memory channel.FastMig MXP 37 Pipe, MXP 3816