Kemppi KMS 400 AS Operating Manual

Contents

ENinstallatiOn3.BeFOre use3.1The product is packed in specially designed transport cartons. However, before use alwaysmake sure the products have not been damaged during transportation.Check also that you have received the components you ordered and the instruction manualsneeded, as described in the Quick start guide pack. Product packaging material is recyclable.NOTE! When moving the welding machine, always lift it from the handle, never pull it from thewelding gun or other cables.Operating environmentThis machine is suitable for both indoor and outdoor use. Always make sure that the air flow tothe machine is unrestricted. The recommended operating temperature range is -20…+40°C.Please ensure you read the safety instructions concerning operating environments supplied inthis manual.distribution networkAll regular electrical devices without special circuits generates harmonic currents into thedistribution network. High rates of harmonic current may cause losses and disturbance tosome equipments.This equipment complies with IEC 61000-3-12 provided that the short-circuit power Sscis greater than or equal to 4.7 MVA at the interface point between the user’s supply andthe public supply network. It is the responsibility of the installer or user of the equipmentto ensure, by consultation with the distribution network operator if necessary, that theequipment is connected only to a supply with a short-circuit power Ssc greater than or equalto 4.7 MVA.MaChine intrOduCtiOn3.2H12H11S11X11X12X146,3AX13 X1501F11F11 Fuse for connection for control table 6.3 A delayed X12 Earth connectionH11 Signal lamp I/O X14 , X15 Connection for control cable parallelH12 Warning lamp for thermal protection 01 Inlet of mains cableS11 Main switch I/OX11, X13 Welding connection parallel6FastMig KMS 400 AS / © Kemppi Oy / 1021