Kemppi Master MLS 2500 Operating Manual

Also see for Master MLS 2500: Operation instructions

Contents

Kemppi Master MLS 2500 Operating Manual Manual pdf 19 page image

ENIf the saved settings need to be adjusted the led has to be moved from ON to SET position inorder to select parameters. Press the SAVE button. It is also possible to save the currently usedparameters by pressing SET when the memory function is in OFF state (no lights on). Channelis cleared if MEMORY and CH buttons are pressed simultaneously in SET mode.3.2.4 adopting the saved settings1. Select MEMORY by pressing the button.2. Select memory channel by pressing the CH button.3. Start welding.3.2.5 remote control memory channelsMemory channels are selected by pressing simultaneously both REMOTE and CH button. Withthe remote control you can retrieve saved settings on memory channels.3.2.6 SeTup functionsA so called SETUP state is included for modifying panel functions. You can enter the SETUPstate by pressing the REMOTE (SETUP) button longer than normally. Exit is performed in thesame way. You can select the function (see list below) by pressing the arrow buttons and thenchange the setting by turning the potentiometer.Display Function Factory settingA1 Upslope with constant time setting /gradient (steepness) setting0 constant timeA2 Downslope with constant time setting /gradient (steepness) setting0 constant timeA3 TIG antifreeze off / on 1 offA4 MMA antifreeze off / on 1 onA5 MMA hot start pulse non adaptive / adaptive 0 non adaptiveA6 Downslope cut off on / off 0 onA7 MMA open circuit voltage 80V / 40V 0 80 VA8 2T downslope normal / cuts off by short switch action 0 normalA9 Tacking automatics off / on 0 offA10 Current at arc start steep / slightly sloped 0 steep.A11 Downslope linear / non-linear 0 linearA12 MMA/TIG method selection with remote control off /on 0 offA13 Search arc off / on 1 onA14 Possibility to current freezing during downslope off / on 0 offA15 Control of channels with torch up-down switch off / on 0 offA16 Control of current with torch up-down switch always active /active only when selected with REMOTE button0 always activeA17 Guard functions of cooling unit not activated / activated 1 activatedA18 Downslope for Minilog and 4T in MTM and MTL panels performedduring long switch action / after switch operation (normal)0 normalA19 Cooling unit operates on forced control / automatic on/off control 0 automatic17Master, MasterTig, MasterCool 10 / © Kemppi Oy / 1112