Kemppi Master MLS 2500 Operating Manual

Also see for Master MLS 2500: Operation instructions

Contents

Kemppi Master MLS 2500 Operating Manual Manual pdf 8 page image

EN2.8 weLding CabLe COnneCTiOnS2.8.1 Choosing welding polarity in MMa weldingYou can change the welding polarity by choosing (+) or (-) cable connector.2.8.2 earthingIf possible, always fasten the earth clamp of return current cable directly onto work piece.1. Clean contact surface of earth clamp from paint and rust.2. Fasten clamp properly, so that contact surface is as large as possible.3. Check that clamp is fastened firmly.2.9 COOLing uniT TO MaSTerCOOL 10NOTE! Cooling liquid is injurious! Avoid also contact with skin or eyes. In case of injury, seek formedical advice.Cooling unit MasterCool 10 together with TIG torch of Kemppi’s TTC-W range enables TIGwelding with water-cooled torch.The cooling unit is installed beneath the power source with screws. Electrical connections areon the bottom of power source. Fill the reservoir with a 20 - 40 % mixture of etanol and water,or with any other suitable antifreeze. The capacity of the reservoir is 3 litres.MasterCool 10:Mastertig MLS 3000Mastertig MLS 4000installation of cooling unit1.2.6Master, MasterTig, MasterCool 10 / © Kemppi Oy / 1112