KEMPPI PRO EVOLUTION, MXE / 0547 – 13© KEMPPI OY22212019181723262524273.3.1. 1-MIG or PulsedMIG synergic curve is selected as followsa) Select 1-MIG or PulsedMIG.b) Select material group. You get from the material group in question the curve with whichwas started last. If the selected material is not the right one, you can browse materials in thematerial group by re-pressing the material group selection key.c) Select shielding gas. Only gas selections possible for the material in question are displayed.d) Select wire diameter. Only diameters possible for the filler wire/gas selection in questioncan be selected. The unit remembers (MEMORY) last selections from each material group(material, gas, wire diameter) separately at 1-MIG and PulsedMIG.3.4. BASIC CONTROLS, BASIC DISPLAYS, WELD DATA17. Control for wire feed speed in MIG/MAG, weldingpower in 1-MIG and PulsedMIG, and welding cur-rent in MMA.18. Display for wire feed speed or MMA current.19. Informative plate thickness display in 1-MIG andPulsedMIG for horizontal vertical fillet weld. Duringwelding true welding current display.20. Control for welding voltage (MIG/MAG), or arclength (1-MIG and Pulsed MIG).21. Display of welding voltage set value with MIG/MAG and 1-MIG. Set value display for arclength with Pulsed-MIG, range -9...0...9. During welding pole voltage of power source isdisplayed. Display is also used as display of welding dynamics control, -9...0...9.22. Pressing the WELD DATA key restores to displays those values of wire feed speed, weldingcurrent and welding voltage which were used when welding was stopped.3.5. WELDING DYNAMICS CONTROL23. Control for MIG/MAG, 1-MIG and MMA welding dynamics. Controlvalue -9...0...9 is displayed in display 21. Welding dynamics controlinfluences welding stability and spatter amount. Zero position is recom-mended as basic setting. Values -9...-1, softer arc in order to reduce spatteramount. Values 1...9, harder arc in order to increase stability, and whenusing 100 % CO2 shielding gas in steel welding.3.6. SELECTIONS FOR MAIN CONTROLS24. Local control, main controls are made from panel potentiometers 17 and 20.25. Gun control, wire feed speed or welding power controls are made fromcontrol unit RMT10, which is mounted to PMT MIG gun. Welding voltageor arc length controls are made from panel potentiometer 20.26. Remote control, main controls are made from control unit R20 connected tomain wire feeder or from PROMIG 100 sub-feeder.27. Control selection key.Note! You cannot select remote control mode or gun remote control mode if thecontrol unit is not connected to the welding equipment.