Kemppi Pro Evolution 3200 Operation Instruction Manual

Also see for Pro 5200 EVOLUTION: Operation instructions

Contents

Kemppi Pro Evolution 3200 Operation Instruction Manual Manual pdf 8 page image

– Kemppi pro evolution 300, 400, 500, 300 mvu, 400 mvu, 500 mvu / 0617 © Kemppi oy05If changing the mains cable take into consideration the following:The cable is entered into the machine through the inlet ring on the rear panel of the machine andfastened with a cable clamp (05). The phase conductors of the cable are coupled to connectorsL1, L2 and L3. The earth protection coloured green-yellow is coupled to connectorIf you are using 5-lead cable, you must connect neutral conductor withterminal N.*) In cables of S type there is a protective grounding conductor coloured green-yellow.2.2.2. Welding and earth cablesRecommended copper cables with cross-sectional area are as follows:Kemppi Pro Evolution 3200 50 ... 70 mm2Kemppi Pro Evolution 4200 70 ... 90 mm2Kemppi Pro Evolution 5200 70 ... 90 mm2In enclosed table are shown typical load capacities of rubber insulated copper cables, whenambient temperature is 25 ºC and lead temperature is 85 ºC.CABLE DUTY CYCLE ED VOLTAGE LOSS / 10m...........................100% .........60% ........... 30%50 mm 2 ..............285 A .........370 A ......... 520 A ...........0,35 V / 100 A70 mm 2 ..............355 A .........460 A ......... 650 A ...........0,25 V / 100 A95 mm 2 ..............430 A .........560 A ......... 790 A ...........0,18 V / 100 ADo not overload welding cables due to voltage losses and heating.Fasten the earth clamp of the return current cable carefully, preferably direct onto the piece to bewelded. The contact surface of the earth clamp should always be as large as possible.Clean the fastening surface from paint and rust.3. operatIon control swItches andpotentIometers and theIr use3.1. maIn swItch I/oWhen you turn the switch into I-position, pilot lamp H11 on the front face is illuminated and themachine is ready for use.Always turn the machine on and off with the mains switch, never use themains plugs as a switch.Sizes of the mains cables and fuse ratings for the machine at 100% duty cycle are specified inthe table below:Rated voltage Mains voltage range Fuses,slow-blowConnectioncable *) mm 2Pro Evolution 3200 400 V 3~ 360 V… 440 V 25 A 4 x 6.0 SPro Evolution 4200 400 V 3~ 360 V… 440 V 35 A 4 x 6.0 SPro Evolution 5200 400 V 3~ 360 V… 440 V 35 A 4 x 6.0 SPro Evolution 3200 MVU 400 V 3~ 230 V 3~ 360 V… 440 V 200 V… 260 V 35 A 4 x 6.0 SPro Evolution 4200 MVU 400 V 3~ 230 V 3~ 360 V… 440 V 200 V… 260 V 50 A 4 x10 SPro Evolution 5200 MVU 400 V 3~ 230 V 3~ 360 V… 440 V 200 V… 260 V 60 A 4 x 16 S