Kemppi Promig 300 Operation Instructions Manual

18 – PROMIG 200, PROMIG 300 / 0537 © KEMPPI OYR61R63R20R10R614. OPERATIONS OF REMOTE CONTROL UNITSIN PROMIG 200 AND 300 WIRE FEED UNITS................ R63 ....................................................... R61MIG ......... Setting for wire feed: ............................. Setting for voltage:................ I 1...18 m/min................ II 1...25 m/min ....................................... 10 V...max. voltage of power source (35...46 V)MMA ....... Setting for power:................ 10 A...max. power of power source....... NO OPERATION................ R61MIG ......... Setting for wire feed:................ I 1...18 m/min................ II 1...25 m/minMMA ....... Setting for power:................ 10 A...max. power of power source5. SERVICE, OPERATION DISTURBANCESThe amount of use and the working environment should be taken into consideration whenplanning the frequency of maintenance of Promig. Careful use and preventive maintenance willhelp to ensure trouble-free operation.The following maintenance operations should be carried out at least every six months:Check:- The wear of the grooves of the feed rolls. Excessive wear of groovescauses problems in wire feed.- The wear of the wire guide tubes of wire feed. Badly worn feed rollsand wire guide tubes should be discarded.- The wire guide tube in the gun should be set as near the feed rolls aspossible, but not touching them and the wire must follow a straight linefrom the end of the feed roll.- Reel brake adjustment- Electric connections* Oxidized couplings must be cleaned* Loose couplings must be tightenedClean dust and dirt from the equipment.When using compressed air, always protect your eyes with propereye protection.In case of problems contact the KEMPPI works in Lahti, Finland or your KEMPPI dealer.twice ayear