Kemppi Promig 520R Operation Instructions Manual

14 – PROMIG 520R, 120R / 0544 © KEMPPI OYMIG basic operationsWelding method selection (S21): no functionControl mode selection (S22): local, remote by robot controllerLocal controls: wire feed speed (R21), welding voltage (R22)Controls for MIG welding dynamics (R23)Digital displays: wire feed speed (P21), current (P22), voltage (P23)Retrieval of last weld values (S23)SELECTO operationsSELECTO mode switch S24OFF: Normal MIG/MAG weldingON: Welding with memory stored values (5 channels)SET: Welding parameters selection and storage SAVE (S25), for selected channel CHANNEL1...5 (S26).Welding method selecting switch S21No function: always two-sequence procedureMIG/MAG welding with two-sequence procedure1. start on: welding starts2. start off: welding stopsControl mode selecting switch S22Local control: Control potentiometers R21 and R22 on panel are operational.Remote control: Voltage and wire feed speed set values controlled by robotcontroller(Switch center = remote position)Local controls R21, R22Wire feed speed potentiometerSELECTO OFF: Local control for wire feed speed 0...18m/min or 0...25 m/minSELECTO ON: No operationSELECTO SET: Local control for wire feed speed 0...18m/min or 0...25 m/minVoltage potentiometerSELECTO OFF: Local control for voltage of PRO powersource, 10 V...max. MIG voltage of power sourceSELECTO ON: No operationSELECTO SET: Local control for voltage of PRO powersource, 10 V...max. MIG voltage of power source