Kemppi Promig 520R Operation Instructions Manual

20 – PROMIG 520R, 120R / 0544 © KEMPPI OYI / A displayMIG/MAG welding with independent controls for wire feed speed and voltage: Display shows 0A before, and true value during welding.SYNERGIC MIG welding: Display shows 0 A before, and true value during welding.SYNERGIC PULSED MIG welding: Display shows in setting state the reference mean currentvalue, and true value for welding current during welding.U / V displayMIG/MAG welding with independent adjustments for wire feed speed and voltage: Display showspre-set value for welding voltage, and true value during welding.SYNERGIC MIG welding: Display shows pre-set value for welding voltage, and true value duringwelding.When adjusting arch length display shows voltage.SYNERGIC PULSED MIG welding: In setting state, display shows set value -9...0...9 for arclength, and true value of welding voltage during welding.Note! Display shows terminal voltage of power source. Depending on length and copper cross-section of welding cables real arc voltage and display may differ (see table below).Cable 50 mm2 70 mm2 95 mm2Voltage loss/10 m 0,35 V/100 A 0,25 V/100 A 0,18 V/100 AWhen you adjust welding dynamics, display V shows adjustment value for welding dynamics-9...0...9, the value is shown for approx. 3 s after end of adjustment. After that display reverts toshow voltage in SYNERGIC MIG and arc length in SYNERGIC PULSED MIG welding.4.2.1. WELD DATARetrieval of welding parameters to displaysUse of WELD DATA switch retrieves welding parameters, wire feed speed, welding current,welding voltage which were used when welding was stopped last. Welding values are indicatedin display for so long you are using the WELD DATA switch and are stored until you press againthe start switch of gun.Testing the gas flowA short press on the switch starts shielding gas flow. Shielding gas flows for approximately 20seconds, or until the switch is pressed again.