Kentec Electronics Sigma XT Plus Operation And Maintenance Manual

Also see for Sigma XT Plus: Operation and maintenance manual

Kentec Electronics Sigma XT Plus Operation And Maintenance Manual Manual pdf 27 page image

Man-1111_SigmaXT+_Coincidence_Unit_18 Page 27 of 36Turn the Enable keyswitch off to leave the disablement active. To re-enable the manual release facility repeatthe procedure above.15.2.3 Disable Stage 1 outputTo disable the 1 st Stage relay output, press the UP button on the module while at access level 2 until thedisplay shows:DISABLEstage 1 output ? Press the Enter button to select this function. The display will show:ENABLESTAGE 1 OUTPUT ? The yellow disabled LED on the module that has been disabledwill be lit.Turn the Enable keyswitch off to leave the disablement active. To re-enable the Stage 1 relay output repeatthe procedure above.15.2.4 Disable Stage 2 outputTo disable the 2 nd Stage relay output, press the UP button on the module while at access level 2 until thedisplay shows:DISABLEstage 2 output ? Press the Enter button to select this function. The display will show:ENABLESTAGE 2 OUTPUT ? The yellow disabled LED on the module that has been disabledwill be lit.Turn the Enable keyswitch off to leave the disablement active. To re-enable the Stage 2 relay output repeatthe procedure above.15.2.5 Disable Released outputTo disable the Released relay output, press the UP button on the module while at access level 2 until thedisplay shows:DISABLEreleased output ? Press the Enter button to select this function. The display will show:ENABLEreleased OUTPUT ? The yellow disabled LED on the module that has been disabledwill be lit.Turn the Enable keyswitch off to leave the disablement active. To re-enable the Released relay output repeatthe procedure above.15.2.6 Disable Extract outputTo disable Extract relay output, press the UP button on the module while at access level 2 until the displayshows:DISABLEextract output ? Press the Enter button to select this function. The display will show:ENABLEextract OUTPUT ? The yellow disabled LED on the module that has been disabledwill be lit.Turn the Enable keyswitch off to leave the disablement active. To re-enable the Extract relay output repeatthe procedure above.15.2.7 Turn on Extract outputTo turn on the extract relay output, press the DOWN button on the module while at access level 2 until thedisplay shows:TURN ONEXTRACT OUTPUT Press the Enter button to select this function. The display will show: