| 
English 7Control an Amp from Center UnitYou can control the sound by controlling amplifiers from the Center Unit.1 Enter AMP Control modeSelect the AMP Control mode by following the procedure given on the Operation Manual of the Center Unit.NOTEUse the set item and value operation buttons by following the instructionsgiven on the Operation Manual of the Center Unit.2 Select an amp number to operateOperate the desired set item with the Center Unit.Select the "AMP NO"/"AMP CONTROL NO" display.NOTEWhen the Center Unit is in the STANDBY mode, message "AMP OFF" isdisplayed and you cannot operate the set items.3 Set an ID number of Amp to operateSet an amp’s ID number on the Center Unit.You can select an ID number of "0" to "7" of connected amps.4 Select the AMP Control item for adjustmentSelect the desired set item on the Center Unit.5 Adjust the AMP Control itemYou can set a value of each item on the Center Unit.The set items and their values are switched and displayed as follows.Display Range Adjustment Item"VOLT"/"CURR"/"TEMP"/"FAN" The amp state is displayed."VOLT" Indicates the source voltage (V)."CURR" Indicates the current consumption (A)."TEMP" Indicates the internal temperature (°F/°C)."FAN" Indicates the rotation speed of the cooling fan in3 steps: "FAST", "SLOW" or "OFF"."BAS F"/"BASS FREQ" 60/80/100/200 (Hz) Bass Center Frequency"BAS G"/"BASS GAIN" –15 — +15 (dB) Bass level"Q FA"/"Q FACTOR" Q1.00/Q1.25/Q1.50/Q2.00 Bass Q Factor"EXT"/"BASS EXT" ON/OFF When the bass extend is set to ON, low frequencyresponse is extended by 20%."VOL"/"VOL OFFSET" –20 — 0 (dB) Volume offset"AMP NO"/"AMP CONTROL NO"0 — 7 Select an ID number of the amp you use.6 Exit AMP Control modeReleases the Amp Control mode by the Center Unit.NOTEWhen you have controlled the bass or treble of the sound using theEqualizer or DSP function of the Center Unit, and when you amplify the samefrequency as that controlled by the Amplifier Control, the sound may bedistorted due to an input overflow.Messages that may be displayed on the Center UnitWhen you are selecting an item with the Amp Control, an error status of theamplifier is displayed on the Center Unit.Display Informations"AMP × E-01"/"AMP × COND E-01" When the inside of the unit is overheating."AMP × E-02"/"AMP × COND E-02" When the unit has failed and direct current voltage is generatedto the speaker’s output.NOTETurn the POWER switch Off and release the protection. If theerror message continues, consult to the Kenwood’s dealership."AMP × E-03"/"AMP × COND E-03" When the speaker cord is shorted.When the speaker output is in contact with the vehicle ground."AMP OFF" When you use the Amp Control in the Standby mode.NOTENumber "×" on the display indicates the amp’s ID number. |
