58Error message listIf an error occurs while using the unit, a messageappears. Take appropriate action according to thefollowing message/remedy/cause list.“No Signal”:• Start the playback on the external componentconnected to the AV-IN1 or iPod/AV-IN2 inputterminal.• Check the cords and connections.• Signal input is too weak.“Miswiring DC Offset Error ”/“Warning DC OffsetError ”:• A speaker cord has shorted or it has come in tocontact with the car chassis. Wire or insulate thespeaker cord as appropriate, then reset the unit.(Pages 3 and 51)“ Parking off”:• No playback picture is shown when the parkingbrake is not engaged.“ Authorization Error”:• Check whether the connected iPod/iPhone iscompatible with this unit. (Page 56)“USB Device Error”:• The USB power voltage is abnormal.• Turn off and turn on the unit.• Connect another USB device.“No Navigation”:• No navigation unit is connected.“Connection Error”:• The device is registered but the connection hasfailed. Connect the registered device. (Page 30)“Please Wait...”:• The unit is preparing to use the Bluetoothfunction. If the message does not disappear, turnoff and turn on the unit, then connect the deviceagain (or reset the unit).“No Voice Device”:• The connected mobile phone does not have avoice recognition system.“No Data”:• No phone book data is contained in the connectedBluetooth phone.“Initialize Error”:• The unit has failed to initialize the Bluetoothmodule. Try the operation again.“Dial Error”:• Dialing has failed. Try the operation again.“Hung Up Error”:• The call has not ended yet. Park your car, and usethe connected mobile phone to end the call.“Pick Up Error”:• The unit has failed to receive a call.“Antenna Error”:• The antenna has a short-circuit and the protectivecircuit has activated.• Check the Digital Radio antenna. If a passiveantenna without a booster is used, set Antennapower “OFF”.REFERENCESREFERENCES