Kenwood DDX6017 Instruction Manual

Also see for DDX6017: Installation manual Instruction manual

Contents

88 EnglishEnglishTroubleshooting GuideThe viewing angle cannot be changed.• The DVD disc being played does not contain therecording of more than one angle.• You are attempting to switch the angle in a DVDsection where more than one angle is not recorded.Playback will not start even after a title is selected.• A viewing restriction (RATING) has been set for thedisc.The voice or subtitle language selected in the initial setting is not played.• The DVD disc being played does not contain therecording of the selected voice or subtitle language.Disc sourceThe disc control mode cannot be selected.• No wire has been connected to the disc changerinput terminal on the unit.The specified disc does not play, but another one plays instead.• The specified CD is quite dirty.• The CD is upside-down.• The disc is loaded in a different slot from thatspecified.• The disc is severely scratched.The sound skips.• Something is touching the disc changer.• The CD is scratched or dirty.The display shows that the changer is being played, but no sound can be heard.• The computer chip in the unit is not functioningnormally.The specified track will not play.• Random play or magazine random play has beenselected.Track repeat, disc repeat, track scan, disc scan, random play, and magazine random play start by themselves.• The setting is not cancelled.Can’t remove disc.• The cause is that more than 10 minutes has elapsedsince the vehicle ACC switch was turned OFF.• The viewing angle cannot be changed when the DVD discbeing played does not contain the recording of more thanone angle.• More than one viewing angle may be recorded only inlimited sections in a disc.• Check the viewing restriction level (RATING) setting.• Use a DVD disc containing the recording of the selectedvoice or subtitle language.• Connect the wire to the disc changer input terminal on theunit.• Clean the CD.• Load the CD with the labeled side up.• Eject the disc magazine and check the number for thespecified disc.• Try another disc instead.• Remove whatever is touching it.• If skipping happens at the same place when the car isstopped, something with the CD is wrong. Clean the CD.• Press the reset button on the unit (see page 4).• Turn off random play or magazine random play.• The settings for these functions remain on until thesetting to off or the disc ejected, even if the power isturned off or the source changed.• The disc can only be removed within 10 minutes of theACC switch being turned OFF. If more than 10 minuteshas elapsed, turn the ACC switch ON again and press theEject button.