32 ENGLISHSettingsSettings3 Rotate the image (1) if necessary, thenconfirm the selection (2).A confirmation message appears. Touch [Enter]to store the new image. (The existing image isreplaced with the new one.)Select the viewing angle in relation to the monitor tomake the image on the screen easier to see.• 0 (Initial)/–1/–2/–3User interface settingsDisplay the screen.On the Home screen, touch as follows:Then, on the screen, touch [User Interface].Assign functions to the keys on the remote controllerof the steering wheel.• This function is available only when your car isequipped with the electrical steering remotecontroller.• You can only register/change the functions whileyou are parked.• If your steering remote controller is not compatible,learning may not be completed and an errormessage may appear.1 When the unit is ready for learning, pressand hold a steering remote controllerbutton for about 2 seconds to register/change.• Refer to the message displayed to confirmwhether the unit ready before proceeding.2 Select a function to assign to the selectedbutton.3 Repeat steps 1 and 2 to register otherfunctions to other buttons.4 Touch [Learning completed] to finishprocedure.A confirmation message appears. Touch [Yes].• The unit can register/change all of the buttons’functions at the same time. To do this, press allbuttons in turn and after pressing all of them, touch[Learning completed] in step 2. However, newfunctions cannot be learned after this operation.• When changing the functions already learned, touchthe assigned function you want to change in step 2and then touch to select the new function from thefunction list.• Confirm the contents of the settable functions in thefunction list. You cannot edit the function list.To initialize the setting: Touch [Learninginitialisation] in step 2.• A confirmation message appears. Touch [Yes].– To cancel the initialization, touch [No].
