Kenwood DMX820WXS Instruction Manual

Connection/Installation44Connection/InstallationBefore InstallationBefore installation of this unit, please note thefollowing precautions.# WARNINGS• If you connect the ignition wire (red) andthe battery wire (yellow) to the car chassis(ground), you may cause a short circuit, thatin turn may start a fire. Always connect thosewires to the power source running throughthe fuse box.• Do not cut out the fuse from the ignition wire(red) and the battery wire (yellow). The powersupply must be connected to the wires viathe fuse.# CAUTION• Install this unit in the console of your vehicle.Do not touch the metal part of this unit duringand shortly after the use of the unit. Metal partsuch as the heat sink and enclosure becomehot.NOTE• Mounting and wiring this product requiresskills and experience. For best safety, leave themounting and wiring work to professionals.• Make sure to ground the unit to a negative 12VDC power supply.• Do not install the unit in a spot exposed todirect sunlight or excessive heat or humidity.Also avoid places with too much dust or thepossibility of water splashing.• Do not use your own screws. Use only thescrews provided. If you use the wrong screws,you could damage the unit.• If the power is not turned ON (“There is anerror in the speaker wiring. Please checkthe connections.” is displayed), the speakerwire may have a short-circuit or touchedthe chassis of the vehicle and the protectionfunction may have been activated. Therefore,the speaker wire should be checked.• If your car’s ignition does not have an ACCposition, connect the ignition wires to a powersource that can be turned on and off with theignition key. If you connect the ignition wireto a power source with a constant voltagesupply, such as with battery wires, the batterymay be drained.• If the console has a lid, make sure to install theunit so that the front panel will not hit the lidwhen closing and opening.• If the fuse blows, first make sure the wiresaren’t touching to cause a short circuit, thenreplace the old fuse with one with the samerating.• Insulate unconnected wires with vinyl tapeor other similar material. To prevent a shortcircuit, do not remove the caps on the ends ofthe unconnected wires or the terminals.• Connect the speaker wires correctly to theterminals to which they correspond. The unitmay be damaged or fail to work if you sharethe ¤ wires or ground them to any metal partin the car.• When only two speakers are being connectedto the system, connect the connectors eitherto both the front output terminals or to boththe rear output terminals (do not mix frontand rear). For example, if you connect the ¢connector of the left speaker to a front outputterminal, do not connect the ¤ connector toa rear output terminal.• After the unit is installed, check whether thebrake lamps, blinkers, wipers, etc. on the carare working properly.• Do not press hard on the panel surface wheninstalling the unit to the vehicle. Otherwisescars, damage, or failure may result.• Reception may drop if there are metal objectsnear the Bluetooth antenna.Bluetooth antenna unit