Kenwood DNN991HD Quick Start Manual

Also see for DNN9710BT: Instruction manual Quick start guide Instruction manual

English ñ 21Ñ Unit1) To prevent a short circuit, remove the key fromthe ignition and disconnect the ¤ terminal ofthe battery.2) Make the proper input and output wireconnections for each unit.3) Connect the speaker wires of the wiring harness.4) Connect the wiring harness wires in thefollowing order;ground, battery, ignition.5) Connect the wiring harness connector to theunit.6) Install the unit in your car.7) Reconnect the ¤ terminal of the battery.8) Press the button. (P.4)9) Perform the Initial Setup.See First Step (P.7).⿠Non-Japanese carsBend the tabs of themounting sleeve witha screwdriver or similarutensil and attach it inplace.⿠Japanese cars6 or 7 6 or 7Car Bracket✎ NOTE• Make sure that the unit is installed securely in place.If the unit is unstable, it may malfunction (eg, thesound may skip).Ñ Trim plate1) Attach accessory 8 to the unit.8⿠General Motors cars (DNN991HD)1) Cut out accessory 4 to meet the shape ofthe opening of the center console.2) Attach accessory 4 to the unit.4Cut out to meet the shape of theopening in the vehicle.⿠Toyota/Scion cars (DNN991HD)1) Cut out accessory 4 as illustrated.Cutting line42) Fold double-sided adhesive (accessory 5)along the slit and attach it to accessory 4cut-out against the center rib as illustrated.Use 2 pieces of accessory 5 for 1 accessory4 cut-out.