English 89Help? ErrorWhen the unit fails to operate correctly, the causeof the failure appears on the display."Protect" :Protective circuit has been activated because a speakercord has shorted or it has come in contact with the carchassis.➡ Wire or insulate the speaker cord as appropriateand then push the Reset button."Hot Error" :When the internal temperature of this unit rises to 60°Cor more, the protection circuit is activated and youmay not be able to operate the unit. At such times thismessage will appear.➡ Use the unit again after reducing thetemperature inside the vehicle."Mecha Error" :The disc player is malfunctioning.➡ Eject the disc and try inserting it again. Contactthe Kenwood dealer if this indicator continuesblinking or the disc cannot be ejected."Disc Error" :Disc is quite dirty.➡ Clean the disc, referring tot he section on (page 4).Disc is upside down.➡ Load the disc with the labeled side up.An unplayable disc is inserted."Region Code Error" :The disc you wanted to play has a region code thatcannot be played with this unit."Parental Level Error" :The disc you wanted to play has a higher level than theparental level you set."No Device" (USB device):The USB device is selected as a source although no USBdevice is connected.➡ Change the source to any source other than USB.Connect an USB device, and change the sourceto USB again."Disconnected" (iPod, Bluetooth audio player):The iPod/Bluetooth audio player is selected as a sourcealthough no iPod/Bluetooth audio player is connected.➡ Change the source to any source other thaniPod/Bluetooth. Connect an iPod/Bluetoothaudio player, and change the source to iPod/Bluetooth again."No Media File" :The connected USB device contains no playable audiofile.Media was played that doesn’t have data recorded thatthe unit can play."USB Device Error!!" :The connected USB device is rated a current capacityhigher than the allowable limit.➡ Check the USB device.Some trouble may have occurred to the connectedUSB device.➡ Change the source to any source other than USB.Remove the USB device."Authorization Error" :Connection to the iPod has failed.➡ Remove the iPod and then reconnect it.The unit does not support the iPod.➡ Refer to this unit> (page 6)."Update your iPod" :The iPod's software is an older version which the unitcan not support.➡ Confirm that the software for the iPod is thelatest version. Refer to connected to this unit> (page 6)."You only can connect one iPod." :More than one iPod are connected to this unit.➡ Connect only one iPod to the USB terminal withiPod tag."Navigation Error. Please turn on power againlater." (DNX series only) :The communication error has occurred due to severelycold temperature.➡ Turn on power again after warming your carinterior."No Navigation" (DDX series only):This unit does not support the connected navigationunit.➡ The latest information on the connectablenavigation unit can be obtained from http://www.kenwood.com/cs/ce.No navigation unit is connected.➡ Connect a supported navigation unit.
