Kenwood DNX7200 Instruction Manual

Also see for DNX7200: Service manual Service manual Instruction manual Instruction manual Installation manual

Contents

English 95When the unit fails to operate correctly, thecause of the failure appears on the display.Protect :Protective circuit has been activated because a speakercord has shorted or it has come in contact with the carchassis.➡ Wire or insulate the speaker cord as appropriateand then push the Reset button.Hot Error :When the internal temperature of this unit rises to 60°Cor more, the protection circuit is activated and youmay not be able to operate the unit. At such times thismessage will appear.➡ Use the unit again after reducing thetemperature inside the vehicle.Hold Error :Activation of the protective circuit when thetemperature inside the disc changer is higher than 60degrees Celsius stops the disc changer from operating.At such times this message will appear.➡ Use when the temperature at the site where thedisc changer has been fitted has dropped.Mecha Error :The disc player is malfunctioning.➡ Eject the disc and try inserting it again. Contactthe Kenwood dealer if this indicator continuesblinking or the disc cannot be ejected.Disc Error :An unplayable disc is inserted.Read Error :• Disc is quite dirty.➡ Clean the disc, referring tot he section on (page 8).• Disc is upside down.➡ Load the disc with the labeled side up.Region code Error :The disc you wanted to play has a region code thatcannot be played with this unit.Parental level Error:The disc you wanted to play has a higher level than theparental level you set.Error 07–67:The unit is not operating correctly due to some reasonor other.➡ Push the unit's Reset button. If the "Error 07−67"message does not disappear, see your nearestKenwood dealer.No Device (USB device)/Disconnected (iPod):The USB device/iPod is selected as a source althoughno USB device/iPod is connected. .➡ Change the source to any source other thanUSB/iPod. Connect an USB device/iPod, andchange the source to USB/iPod again.No Music:The connected USB device contains no playable audiofile.Media was played that doesn’t have data recorded thatthe unit can play.USB Device Error!!:The connected USB device is rated a current capacityhigher than the allowable limit.➡ Check the USB device.Some trouble may have occurred to the connectedUSB device.➡ Change the source to any source other than USB.Remove the USB device.Authorization Error:Connection to the iPod has failed.➡ Remove the iPod and then reconnect it.The unit does not support the iPod.➡ Refer to this unit> (page 7).Update your iPod:The iPod's software is an older version which the unitcan not support.➡ Confirm that the software for the iPod is thelatest version. Refer to connected to this unit> (page 7).EXT SW: Error:Connection to the external device has failed.➡ Remove the external device and then reconnectit.➡ Turn off the power or ACC and turn it back on.Help? Error