Kenwood DNX8160X Instruction Manual

Contents

3 Select the map.4 Select an option:• To zoom in or out, select or .• To rotate the map view, select .• To switch between North Up and 3-Dviews, select .• To add or remove map layers, select.• To view specific categories, select .• To center the map on your currentlocation, select .• To view shortcuts for map andnavigation features, select .Adding a Point to a RouteBefore you can add a point, you must benavigating a route.1 From the map, select > Where To?.2 Search for a location.3 Select a location.4 Select Go!.5 Select Add to Active Route.Taking a DetourWhile navigating a route, you can usedetours to avoid obstacles ahead of you,such as construction zones.While navigating, select > Detour.Stopping the RouteFrom the map, select > Stop.Using Suggested RoutesBefore you can use this feature, you mustsave at least one location and enable thetravel history feature (Device and PrivacySettings).Using the myTrends™ feature, your devicepredicts your destination based on yourtravel history, the day of the week, and thetime of day. After you have driven to a savedlocation several times, the location mayappear in the navigation bar on the map,along with the estimated time of travel, andtraffic information.Select the navigation bar to view asuggested route to the location.About Exit ServicesNOTE: You must be on a major highway orroad to view exit services.While navigating a route, you can findbusinesses and services near upcomingexits. Services are listed by category.GasFoodLodgingRestroomsFinding Exit Services1 From the map, select > Exit Services.2 Use the arrows to select an upcomingexit.3 Select an exit service tab.4 Select a point of interest.Navigating to an Exit1 From the map, select > Exit Services> .2 Select Go!.Avoiding Road Features1 Select Settings > Navigation >Avoidances.2 Select the road features to avoid on yourroutes, and select Save.About Custom AvoidancesCustom avoidances allow you to avoidspecific areas and sections of road. You canenable and disable custom avoidances asneeded.Avoiding an Area1 Select Settings > Navigation > CustomAvoidances.2 If necessary, select Add Avoidance.3 Select Add Avoid Area.4 Select the upper-left corner of the area toavoid, and select Next.5 Select the lower-right corner of the areato avoid, and select Next.The selected area is shaded on the map.6 Select Done.Navigation 5