Kenwood DNX893S Quick Start Manual

Also see for DNX5160BTS: Instruction manual Quick start guide Instruction manual Instruction manual

DNX893S/ DNX773S/ DNX693S/ DNX573S:Ñ FCC WARNINGThis equipment may generate or use radio frequency energy.Changes or modifications to this equipment may causeharmful interference unless the modifications are expresslyapproved in the instruction manual. The user could losethe authority to operate this equipment if an unauthorizedchange or modification is made.NOTEThis equipment has been tested and found to comply withthe limits for a Class B digital device, pursuant to Part 15 of theFCC Rules. These limits are designed to provide reasonableprotection against harmful interference in a residentialinstallation.This equipment may cause harmful interference to radiocommunications, if it is not installed and used in accordancewith the instructions. However, there is no guarantee thatinterference will not occur in a particular installation. If thisequipment does cause harmful interference to radio ortelevision reception, which can be determined by turning theequipment off and on, the user is encouraged to try to correctthe interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment andreceiver.• Connect the equipment into an outlet on a circuit differentfrom that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technicianfor help.#CAUTIONUse of controls or adjustments or performance of proceduresother than those specified herein may result in hazardousradiation exposure.In compliance with Federal Regulations, following arereproductions of labels on, or inside the product relating tolaser product safety.JVC KENWOOD Corporation2967-3, ISHIKAWA-MACHI,HACHIOJI-SHI, TOKYO, JAPANTHIS PRODUCT COMPLIES WITH DHHSRULES 21 CFR SUBCHAPTER J IN EFFECT ATDATE OF MANUFACTURE.Location: Top plateDNX893S/ DNX773S/ DNX693S/ DNX573S:Ñ IC (Industry Canada) NoticeThis device complies with Industry Canada licence-exemptRSS standard(s).Operation is subject to the following two conditions:(1)This device may not cause interference, and(2) this device must accept any interference, includinginterference that may cause undesired operation of thedevice.The term “IC: ” before the certification/ registration numberonly signifies that the Industry Canada technical specificationwere met.#CAUTIONThis equipment complies with FCC/IC radiation exposurelimits set forth for an uncontrolled environment andmeets the FCC radio frequency (RF) Exposure Guidelines inSupplement C to OET65 and RSS-102 of the IC radio frequency(RF) Exposure rules. This equipment has very low levels ofRF energy that it deemed to comply without maximumpermissive exposure evaluation (MPE). But it is desirable thatit should be installed and operated keeping the radiator atleast 20cm or more away from person’s body (excludingextremities: hands, wrists, feet and ankles).Under Industry Canada regulations, this radio transmittermay only operate using an antenna of a type and maximum(or lesser) gain approved for the transmitter by IndustryCanada. To reduce potential radio interference to other users,the antenna type and its gain should be so chosen that theequivalent isotropically radiated power (e.i.r.p.) is not morethan that necessary for successful communication.DNX893S/ DNX773S/ DNX693S/ DNX573S:• Contains Transmitter ModuleFCC ID : ZWY8811X• Contains Transmitter ModuleIC: 12033A-8811X

/ 64

Related manuals for Kenwood DNX5160BTS