Kenwood DPX-6020 Instruction Manual

Kenwood DPX-6020 Instruction Manual Manual pdf 22 page image

Direct Alphabet Input(Function of remote)You can directly input letters using the number/letter entrybuttons on the remote.Example: Use the following table to enter the name "DANCE".Continue steps 3 and 4 until all the characters are chosen forthe name.Press either the NAME button on the main unit or the OKbutton on the remote.The disc name is stored and the disc name preset mode iscanceled.If you make no entry in a 10-second period, the name will bestored with the characters input so far.• Up to 8 characters and 50 disc names can be registered in CDmode and external disc control mode.51st Disc Name Preset is made, the oldest disc name will beautomatically erased to make room for the new setting.• Discs are identified by their total length and number of tracks. Ifanother disc happens to have the same specifications as onethat you have already stored a name for, the name will bedisplayed for it, too.• If you want to change the name of a disc, repeat steps 1 and 2to display the name, and then repeat steps 3 and 4 to input thechanges.• Disc names remain stored even if the reset button is pressed.• This function cannot be used when an MD is played with theMD changer "KMD-D401/KMD-D400/KMD-C30".NOTE65Button to press # Times pressedCharacter#3 11#2#6 2#2 3#3 2“D”“A”“N”“C”“E”NOTEStore the names of discs to be displayed when played.Play the disc whose name you want to preset.• This function is available only for the CD player of this unit anddisc changers that feature the Disc Name Preset function.• This procedure is not to be used to store the disc and track titlesfor MDs that you record.• This function cannot be available during the clock display andwhile using disc scan or magazine random play.Press the NAME button for at least two seconds."Name Set" is displayed and the disc name preset mode isentered.The cursor blinks in the position where character input can bemade.Press either the 4 or ¢ button to move the cursor to thedesired position.The 4 button moves the cursor to the left, and the ¢button to the right.You can also move the cursor left or right by pressing theTRACK+ or TRACK– buttons, respectively, on the remotecontrol.Each time the 38 button is pressed, the characters to beentered change as listed below.Press the DISC + or DISC – button to display the desiredcharacter.Characters that can be displayed are as follows.Alphabet (upper case): _ A ~ ZAlphabet (lower case): _ a ~ zNumerals and symbols: _ 0~9 / + - ✽ = & " ˚ ' < > [ ]432NOTE1Presetting Disc NamesCD/External disc control features— 22 —English