Kenwood DPX-MP5100U Instruction Manual

Also see for DPX-MP5100U: Firmware update guide Service manual

Kenwood DPX-MP5100U Instruction Manual Manual pdf 12 page image

12 | EnglishTuner/TV control featuresFunction of remote controlDirect Access TuningEntering the frequency and tuning.1 Select the bandPress the [FM] or [AM] button.2 Enter Direct Access Tuning modePress the [DIRECT] button on the remotecontrol."– – – –" is displayed.3 Enter the frequencyPress the number buttons on the remotecontrol.Example:Desired frequency Press button92.1 MHz (FM) [0], [9], [2], [1]810 kHz (AM) [0], [8], [1], [0]Cancelling Direct Access TuningPress the [DIRECT] button on the remotecontrol.⁄• You can enter the FM band frequency in steps of aminimum of 0.1 MHz.Station Preset MemoryPutting a station in the memory.1 Select the bandPush the Control knob towards [FM] or [AM].2 Select the frequency to put in the memoryPush the Control knob towards [4] or [¢].3 Put the frequency in the memoryPress the desired [1] — [6] button for at least 2seconds.The preset number display blinks 1 time.On each band, 1 station can be put in the memoryon each [1] — [6] button.Auto Memory EntryPutting stations with good reception in the memoryautomatically.1 Select the band for Auto Memory EntryPush the Control knob towards [FM] or [AM].2 Open Auto Memory EntryPress the [AME] button for at least 2 seconds."A-MEMORY" is displayed.When 6 stations that can be received are put in thememory Auto Memory Entry closes.Preset TuningRecalling the stations in the memory.1 Select the bandPush the Control knob towards [FM] or [AM].2 Recall the stationPress the desired [1] — [6] button.Frequency Step SettingChanging the tuning frequency step.The original setting is FM band 50 kHz, and AMband 9 kHz.1 Turn the power OFFPress the [SRC] button for at least 1 second.2 Switch the frequency stepWhile pressing the [1] and [5] buttons, press the[SRC] button.Release the [SRC] button first, after the displayappears, release your fingers from the [1] and [5]buttons.The frequency step changes to FM band 200 kHz,and AM band 10 kHz.⁄• When the same operation is repeated, the frequencystep returns to the original setting.• When the frequency step is changed, the frequencies inthe memory are deleted.