Kenwood DPX-MP5100U Instruction Manual

Also see for DPX-MP5100U: Firmware update guide Service manual

Kenwood DPX-MP5100U Instruction Manual Manual pdf 7 page image

English | 7AttenuatorTurning the volume down quickly.Press the [ATT] button.Each time you press the button, the Attenuatorturns ON and OFF.When the Attenuator is ON, the "ATT" indicatorblinks.System QSelecting the best sound setting preset for differenttypes of music.1 Select the source to setPress the [SRC] button.2 Select the Sound typePress the [Q] button.When you press the button once, the currentsound setting is displayed.Each time you press the button, the sound settingalternates.Sound setting DisplayUser memory "USER"Rock "ROCK"Pops "POPS"Easy "EASY"Top 40 "TOP40"Jazz "JAZZ"Natural "NATURAL"⁄• User memory: The values set on the

(page 7).• Change each setting value with the (page 9).First, select the speaker type with the Speaker setting.Audio Control1 Select the source to adjustPress the [SRC] button.2 Enter Audio Control modePress the [VOL] knob.3 Select the Basic Audio item to adjustPress the [VOL] knob.Each time you press the knob, the item to beadjusted alternates between the items shown inthe table below.4 Adjust the Basic Audio itemTurn the [VOL] knob.Adjustment Item Display RangeRear Volume "R-VOL" 0 — 35Subwoofer level "SW L" –15 — +15Bass level* "BAS L" –8 — +8Middle level* "MID L" –8 — +8Treble level* "TRE L" –8 — +8Balance "BAL" Left 15 — Right 15Fader "FAD" Rear 15 — Front 15Exit Audio Control mode (Volume control mode)* You can adjust these items in detail. Refer to the detail of Audio Control> (Page8).* Source tone memory: Puts the set up value in thememory per source. (Detail Audio item is included)5 Exit Audio Control modePress any button.Press a button other than the [VOL] knob and [ATT]button.