Kenwood DPX-U5130BT Instruction Manual

Also see for DPX-U5130: Service manual

English | 29Initial settingsYou can configure initial settings of this unit.1 Select the Standby source.Refer to (page 10).2 Press and hold the [AUDIO] button.Enter the Function setting mode.3 Use the [Control knob] to select “INITIAL SET”.For how to use the [Control knob], refer to select the item> (page 9).4 Use the [Control knob] to select an Initialsetting item.Display Description“PRESET TYPE” Sets the Tuner preset type.“TYPE NORMAL”: 1 station can be assigned to1 preset button in each of 4 bands (FM1, FM2,FM3, and AM), i.e., a total of 24 stations (6stations x 4 bands) can be preset.“TYPE MIX”: A total of 6 stations can beassigned to a total of 6 preset buttonsregardless of band (FM1, FM2, FM3, andAM). You can recall a preset station withoutswitching between bands.“KEY BEEP” Setting the operation check sound (beepsound) ON/OFF.“ON” / “OFF”“PANDORA SRC” Sets whether to display Pandora during sourceselection.“ON” / “OFF”“AHA SRC” Sets whether to display aha during sourceselection.“ON” / “OFF”(Function of DPX-U5130BT)“BUILT-IN AUX” Sets whether to display AUX during sourceselection.“ON” / “OFF”“CD READ” Sets the method for reading CD.When unable to play a special format CD, setthis setting to “2” to force playing. Note thatsome music CDs may be unplayable evenwhen set to “2”.In addition, audio files cannot be played whenset to “2”. Normally, keep this set to “1”.1: Automatically distinguishes between theaudio file disc and music CD when playinga disc.2: Forces playing as a music CD.“SWITCH PREOUT” Switches the preout between rear output andsubwoofer output.“REAR”: Rear output“SUB-W”: Subwoofer output(Function of DPX-U5130)“SP SELECT” Sets the speaker type so that the System Qvalue is optimal.“OFF”: OFF“5/4”: For 5 & 4 in. speaker“6*9/6”: For 6 & 6x9 in. speaker“O.E.M.”: For the OEM speaker“F/W UPDATE” Upgrades the firmware.When the firmware version appears, press[Control knob].Selecting “YES” and then pressing the [Controlknob] starts upgrading the firmware.For how to update the firmware, access ourweb site.http://www.kenwood.com/cs/ce/( : Factory setting)5 Use the [Control knob] to select a setting.The previous item appears.Exit the Function setting mode.Press and hold the [6] button.